Vol 6, No 1 (2013)
Table of Contents
Technology
| Rational Design of Process Simulation Models Using Manufacturing System Design Decomposition | |
| N. Murray and K. Taraman | 1-9 |
| Design and Development of Electronic Fuel Injection Control System Program for Single Cylinder Diesel Engine | |
| S. Sittichompoo, Kampanart Theinnoi and B. Sawatmongkhon | 11-17 |
| The Study of the Springback Effect in the UHSS by U-bending Process | |
| N. Sae-Eaw, Chan Thanadngarn, Kampanat Sirivedin, V. Buakaew and Y. Neamsup | 19-25 |
| Investigation of the Parameters Affecting the Die Failure in High Extrusion Ratio of Aluminium Square Hollow Profile by Using Viscoplastic Finite Element Modelling | |
| Yingyot Aue-u-lan, K. Khansai, Piboon Sinpayakun and Chalie Tragangoon | 27-33 |
| Determination of Optimal Preform Part for Hot Forging Process of the Manufacture Axle Shaft by Finite Element Method | |
| V. Sukjantha and Yingyot Aue-u-lan | 35-42 |
| Manufacturing Systems Design Decomposition and Process Failure Mode Effect Analysis | |
| N. Murray, M. O’Connor and K. Taraman | 43-49 |
| Gear Tooth Profile Error caused by Hob Misalignment | |
| kosuchon Satayotin, prasert Prachprayoon and Yasuaki Hiroo | 51-55 |
| The measures to improve the manufacturing process by using the lean concept for hard disk drive industry | |
| P. Sungkamee and P. Peerapattana | 57-66 |
| Knowledge Synthesis Using Multichannel of Media in the Case Study of Integrated Circuit Industry | |
| V. Hirunyasiri and Suthep Butdee | 67-79 |
| The Integrated Learning System on Technical English for Communication in Careers…How and what is it? | |
| Phaop Phuangnoi, Nataya Kaewsai, S. Lerkbangplad and Bubpha Setobol | 81-86 |
.png){kind=logo}
