Page Header

Injury Risks of Rear Occupant in Typical Four-door Type of Pick-up Truck under Vehicle Collision

Saiprasit Koetniyom, Saharat Chanthanumataporn, Julaluk Carmai, Manus Dangchat, Songwut Mongkonlerdmanee, Sthaphorn Wannapor

Abstract


This research explores the injury risks of occupants in four-door type of pick-up truck using experimental based collision with Hybrid III dummy for occupant injury indicators. The full-sized crash laboratory was developed to conduct full frontal impact based on standard regulation. To verify performance of full-sized crash laboratory and vehicle deceleration, low and high speed tests were conducted at the same vehicle. The Hybrid III dummy with head and chest sensors was used at the rear outboard seat during high speed test. Consequently, the deflection and thoracic viscous criteria, which represent the chest injuries, are up to 93 mm and 3.96 m/s, respectively, high beyond the standard requirement. Moreover, the most important finding of this research is that the four-door pickup truck is subjected to the 2nd impact up to 116.51 G at dummy head with higher resultant acceleration than the 1st impact (65.62 G) due to the limited space behind the rear headrest and thinner backrest of rear seat. This research also investigates the post-crash results to illustrate the suggestive idea for improving crashworthiness of future design resulting in mitigation of occupant injuries.

Keywords



[1] P. Warr and A. Kohpaiboon, “Explaining Thailand’s automotive manufacturing success,” Journal of Southeast Asian Economies, vol. 35, no. 3, pp. 425– 448. 2018.

[2] J.-L. Martin, A. Lardy, and S. Compigne, “Specificities of rear occupant protection: Analysis of french accident data,” in Proceeding of IRCOBI Conference, 2010, p. 315.

[3] A. Żuchowski, “Risk of injury for the front and rear seat passengers of the passenger cars in frontal impact,” Journal of KONES, vol. 19, no. 3, pp. 507–518, 2012.

[4] Office of Transport and Traffic Policy and Planning, “Status report of road accident analysis from Ministry of Transportation in 2019,” Bangkok, Thailand, 2019.

[5] K. Ono, K. Kaneoka, A. Wittek, and J. Kajzer, “Cervical injury mechanism based on the analysis of human cervical vertebral motion and headneck- torso kinematics during lowspeed rear impacts,” SAE Transactions, vol. 106, pp. 3859– 3876, 1997.

[6] K.-U. Schmitt, M. H. Muser, F. H. Walz, and P. F. Niederer, “N km--a proposal for a neck protection criterion for low-speed rear-end impacts,” Traffic Injury Prevention, vol. 3, no. 2, pp. 117– 126, 2002.

[7] O. Boström, R. Fredriksson, Y. Håland, L. Jakobsson, M. Krafft, P. Lövsund, M. H. Muser, and M. Y. Svensson, “Comparison of car seats in low speed rear-end impacts using the BioRID dummy and the new neck injury criterion (NIC),” Accident Analysis & Prevention, vol. 32, no. 2, pp. 321–328, 2000.

[8] K. B. Arbogast, S. Balasubramanian, T. Seacrist, M. R. Maltese, J. F. García-España, T. Hopely, E. Constans, F. J. Lopez-Valdes, R. W. Kent, H. Tanji, and K. Higuchi, “Comparison of kinematic responses of the head and spine for children and adults in low-speed frontal sled tests,” Stapp Car Crash Journal, vol. 53, pp. 329–372, Nov. 2009.

[9] N. Dharwadkar and K. P. Adivi, “Modelling of engine suspension components for crash simulations,” M.S. thesis, Department of Applied Mechanics, Chalmers University of Technology, 2011.

[10] World Health Organization, “Decade of action for road safety 2011–2020,” World Health Organization, Geneva, Switzerland, 2011.

[11] J. K. Foster, J. O. Kortge, and M. J. Wolanin, “Hybrid III-A biomechanically-based crash test dummy,” SAE Transactions, vol. 86, no. 4, pp. 3268–3283, 1977.

[12] J. A. Newman, “Head Injury Criteria in Automotive Crash Testing,” SAE Transactions, vol. 89, pp. 4098–4115, 1980.

[13] The United Nations Economic Commission for Europe (UNECE), “Regulation No. 94 Uniform provisions concerning the approval of vehicles with regard to the protection of the occupants in the event of a frontal collision,” 2017. [Online]. Available: https://unece.org/fileadmin/DAM/ trans/main/wp29/wp29regs/2017/R094r3e.pdf

[14] The United Nations Economic Commission for Europe (UNECE), “Regulation No. 127 Uniform provisions concerning the approval of motor vehicles with regard to their pedestrian safety performance,” 2018. [Online]. Available: https:// unece.org/fileadmin/DAM/trans/main/wp29/ wp29regs/2018/R127r2e.pdf

[15] The United Nations Economic Commission for Europe (UNECE), “Regulation No. 80 Uniform provisions concerning the approval of seats of large passenger vehicles and of these vehicles with regard to the strength of the seats and their anchorages,” 2011. [Online]. Available: https:// unece.org/fileadmin/DAM/trans/main/wp29/ wp29regs/R080r1e.pdf

[16] ASEAN NCAP, “Frontal Impact Testing Protocal,” 2019. [Online]. Available: http://www.aseancap. org/v2/wp-content/uploads/2020/01/5.-ASEANNCAP- Asessment-Protocol-Child-Occupant- Protection-2.0_2019_FINAL_15-NOV-2019.pdf

[17] The United Nations Economic Commission for Europe (UNECE), “Regulation No. 33 Uniform provisions concerning the approval of vehicles with regard to the behavior of the structure of the impacted vehicle in a head-on collision,” 1993. [Online]. Available: https://unece.org/fileadmin/ DAM/trans/main/wp29/wp29regs/r033r1e_1.pdf

[18] Y. Peng, Y. Wei, and M. Zhou, “Efficient modeling of cable-pulley system with friction based on arbitrary-Lagrangian-Eulerian approach,” Applied Mathematics and Mechanics, vol. 38, pp. 1785–1802, 2017.

[19] L. Dong, H. Mao, G. Li, and K. H. Yang, “Investigation of pediatric neck response and muscle activation in low-speed frontal impacts,” Computer Methods in Biomechanics and Biomedical Engineering, vol. 18, no. 15, pp. 1680– 1692, 2015.

[20] B. J. Hardy, “A study of accidents involving bull bar equipped vehicles,” Transport Research Laboratory, Crowthorne, England, TRL report 243, 1996.

[21] Y. Ahmad, W. J. Yahya, K. A. Abu Kassim, S. Koetniyom, J. Carmai, and H. abd Kadir, “Driver head kinematic analysis under frontal offset collision during the rebound phase,” International Journal of Crashworthiness, vol. 24, no. 6, pp. 606– 614, 2019.

[22] J. Hutchinson, M. J. Kaiser, and H. M. Lankarani, “The head injury criterion (HIC) functional,” Applied Mathematics and Computation, vol. 96, no. 1, pp. 1–16, 1998.

[23] Y. Liu, “Development of simplified truck chassis model for crash analysis in different impact scenarios,” International Journal of Crashworthiness, vol. 15, no. 5, pp. 457–467, 2010.

[24] J. Kisilowski and J. Zalewski, “Evaluation of possibilities of a motor vehicle technical condition assessment after an accident repair in the aspect of road traffic safety,” in International Conference on Transport Systems Telematics, 2013, pp. 441– 449.

[25] F. M. Favarò, N. Nader, S. O. Eurich, M. Tripp, and N. Varadaraju, “Examining accident reports involving autonomous vehicles in California,” PLoS One, vol. 12, no. 9, p. e0184952, 2017.

[26] S. Jothee, M. S. Shafie, and F. M. Nor, “Fatal penetrating neck injury due to defective airbag inflator,” Forensic Science International, vol. 291, pp. e4–e7, 2018.

Full Text: PDF

DOI: 10.14416/j.asep.2021.12.001

Refbacks

  • There are currently no refbacks.